Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain

Hinumerik
Hitachi
Mazak
. . . M Plus
. . . M32 Plus

. . . M32
. . . T32 M2
. . . M2
. . . T2

. . . T Plus
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Mazak M32

Parameter Value Comments  
 
G19 3

3 = Baud rate 2400
5 = 600
4 = 1200
3 = 2400
2 = 4800

G20 3 = 2 Stop Bits
G22 0 = Even Parity
G23 3 = 8 Data Bits (Set DNC Software to 7 Databits)
G24 1  
G25 0  
G26 0  
G27 0 Use ISO
G28 0  
G29 3  
   

Note: Even though the Mazak may be set to 8 Databits No Parity - ensure that the DNC software is set to 7 databits with Even Parity.

In the DNC Software select xOn/xOff flow control

RS232 Cable.
9pin computer to 25pin CNC

The simple three wire cable shown above is the most common for this type of control and is compatible with the xOn/xOff (DC1/DC3) flow control suggested on this page.

If you intend using RTS/CTS flow control then an alternative cable shown here is compatible with both xOn/xOff and RTS/CTS.