| By: TomRregalmold | Posted on: Feb 26 2010 at 07:40:28 PM | We were using an older version of Easy DNC, drip feeding an Ensu VMC430, with Fanuc 11M. Things worked very well. Due to a power surge we had to re-load all software, operating system, as well as Dasy DNC. Due to our wonderful record keeping system we didn't have the config info saved. After some head scratching we have come up with our config, but it has 'buffer overflow' problems. We are running xon, xoff, wait any. With a baud rate of 2400, delay set to 200. I have changed the fifo setting to 1. What else can I do to eliminate the buffer overflow problems?
| |
