Having a problem drip feeding to tnc2500 heidenhain control from xp.
Getting an error message `data incorrect H` on cnc control when control buffer is full. have tried all the different configurations i can think of but no joy.[/code]
By: Support
Posted on: Jul 19 2007 at 07:45:18 PM
Responded to this by email
By: Guest
Posted on: Jul 23 2007 at 07:20:30 PM
Test
By: Rashid Ahmed
Posted on: Nov 5 2009 at 07:50:55 AM
Dear Sir
We have recently purchased a second hand machine with the below mentioned specifications:
Bridgeport Interact 720 CNC Vertical Machining Center with Heidenhain TNC-2500 Controller
We are facing severe problem in maching operations with the subject machine. The machine successfully receives the program transferred, but the program gets struck when it travels to y side. The machine does not display any sort of error on its pannel. However, the manual operations on the machine could be performed even after the original program gets struck.
Kindly guide us with some possible solution to this problem.
Regards
Rashid Admed
rashid_ppfan@hotmail.com
Reply - add a comment to this topic.
You may enter letters, numbers and standard punctuation only. HTML and other scripts/tags will be rejected.
