Topic: Mesage apperar "tape parity ?"

By: Totoks75@yahoo.com

Posted on: Aug 25 2010 at 02:40:48 PM

hi expert,
please help me, i have transfered some code to CNC, the msg appear :
- transfer read.. with no file name appear,
- reading information valid
- tape parity ?
what does it mean ? since nothing was not transferred to CNC

pls any expert can help me ?

By: Support,

Posted on: Aug 25 2010 at 08:30:27 PM

Are all the settings correct ?

Are your settings available at www.dncsetup.com

By: totoks75@yahoo.com,

Posted on: Aug 28 2010 at 10:28:41 PM

hi expert,
thanks very much for your help and support,
after resetting all bios setup to factory default on PC,
then some settings modification on CNC, i am able to transfer the file with no error message apear again.

thanks for any support.

By: totoks75@yahoo.com,

Posted on: Aug 28 2010 at 10:37:29 PM

just to add information,
i am using easyDNC 4.7 thats make some configuration on Serial A or B to working as a must.
i have also installed Com.Diag to ensure that the port of Com1 and Com2 are working well, and easyDNC can use them.

Topic: Mesage apperar "tape parity ?"

Reply to this topic